Martin Professional Ego X4, Руководство пользователя

Страница: 17 / 44

Stand-alone operation 17
S
TAND
-
ALONE OPERATION
The Ego X Series can be operated without a controller in stand-alone
mode. In this mode, a fixture can be operated as a single unit or in a
“master/slave” configuration together with other Ego X Series fixtures of
the same type. In stand-alone mode, light effects are selected at random
in response to either auto trigger or music trigger signals from the built-in
sensor.
Several options are available to modify stand-alone operation. This
chapter describes these options and explains how to select them using
the DIP-switch on the connections panel.
Overviews of the DIP-switch settings for each Ego X Series model are
included on pages 34 - 40 of this manual.
Important! An Ego X Series fixture transmits a signal when it is set as
master (i.e. DIP-switch pins 1 or 2 and 10 are set to ON). To
avoid damage to the electronics, do not connect more than 1
transmitting device (master or controller) to the data link.
Do not use DIP-switch pin 3 in stand-alone mode. When pin 3
and 10 are both set to ON, the fixture enters effect-wheel
adjustment mode.
S I N G L E - F I X T U R E O P E R A T I O N
An Ego X Series fixture can be set to operate independently of other
fixtures in music trigger or auto trigger mode. A data link is not needed.
Single-fixture mode can be selected by setting all DIP-switch pins to OFF,
setting pin 10 to ON, then setting pin 1 to ON for music trigger or 2 to ON
for auto trigger.
10 2 3 4 5 1 8 6 7 9 ON 12 11 10 2 3 4 5 1 8 6 7 9 ON 12 11
Single fixture
music trigger mode
Single fixture
auto trigger mode