Again, the bracket position and orientation will be determined by the angle setting
required for that Omniline® module.
Remove the linking pins if necessary and fit the bracket in the correct orientation.
Angle the Omniline® module and replace the linking pins at the required angle.
7.4
Fit the second HAM03192 tie-bracket, to the top Omniline® module.
7.5
Refit the lids
7.6
Fit the Collar to the U-bracket using the M10 x 65 Cap Head Machine Screw, in the
orientation shown below.
Tip!
Leave the U-bracket screw (right above) and clamping screw (left above) finger tight
until the system is mounted onto the wall bracket – remembering to tighten them fully
at that stage.
All material © 2009. Martin Audio Ltd. Subject to change without notice.
21
