Martin Audio Installed System Digital Management Processor Engineer 418, Руководство пользователя

Страница: 14 / 38

ENGINEERHARDWAREMANUAL1.1[1].doc 12
2.4 Installation requirements
The Martin Audio Engineer 418 is designed for 19” rack-mount use.
Mount the Martin Audio Engineer 418 with racking screws in a 19” cabinet. Use support strips as
necessary to support the rear of the device.
Adequate ventilation and rear-support must be provided. Allow for enough ventilation into the 19” cabinet
in which the Martin Audio Engineer 418 is mounted. Observe the environmental specifications (see
appendix 2) at all times.
When mounting the Martin Audio Engineer 418 in a touring rack, a touring rack with shock-absorbing
racking strips should always be used.
Always install the Martin Audio Engineer 418 in a level plane. A maximum allowable angle of 10 degrees
is acceptable.
Do not use the Martin Audio Engineer 418 in a wet/damp environment.
Do not block any ventilation slot at any time and check the proper function of the fans at regular
basis. If the fans do not operate properly, the lifespan of the device will be significantly reduced
and the device may even fail.
2.5 Connecting Audio
Use only certified balanced & shielded audio signal cabling (e.g. Belden 8718, Tasker C208). Refer to the
next paragraph for maximum allowable conductor cross sections.
The connectors on the Martin Audio Engineer 418 accept 12-pin Phoenix terminal blocks (as supplied).
Refer to the next paragraph for instructions how to terminate the audio wiring.
From left-to-right are INTPUT 1-4 and OUTPUT 1-8. The connections are labeled: (please refer to rear
panel layout)
+
For audio hot
- For audio cold
For audio ground
Attention: Martin Audio strongly recommends the use of balanced audio connections only.