![background image](http://html.mh-extra.com/html/martin-audio/engineer/engineer_user-manual_1732933045.webp)
All material © 2007. Martin Audio Ltd. Subject to change without notice.
45
12.
Remote control
When you have created zones on the Engineer, you can use the Engineer Remote to control
the volume of the zones you have created in the software and the master volume of the
device. Beside that you can recall presets on the Remote Control.
12.1
Recalling presets
To recall a preset from the Engineer Remote, just press the ‘Preset’ up or down arrow, the
display will show ‘selecting’ and the name of the preset. After 3 seconds the currently
selected preset is recalled.
12.2
Changing volumes
To change a volume of a zone, just press ‘Zone’ up or down arrow. The display will show the
zones you have created and the MASTER volume. Once you have selected the correct zone
you alter the volume through the ‘Volume’ up down arrows.
12.3
Connection
The Engineer Remote is connected through the RS-485 connector using an RJ-45 plug on
the rear panel of the device. This allows you to make cable runs of up to a 1000 ft on
standard CAT-5 cable. Up to four remote panels can be connected to the Engineer by using
the Engineer Remote Hub.
ATTENTION:To use the Engineer Remotes, DISCONNECT THE PC FROM THE
ENGINEER