Martin Audio CDD Series, Руководство пользователя

Страница: 36 / 64

CDD User Guide V1.1
36
CDD
USER GUIDE
Next mount the side bars to the top and bottom of the cabinet. The two side bars included in
the yoke assembly are identical but the correct screws and spacers must be used at each end.
Two lengths of M8 socket head countersunk screw are supplied: 40 mm and 45 mm; there are
also two pairs of spacer bushes, of different thicknesses. The longer screw and the thicker bush
MUST be used with the bar on the bottom of the cabinet: this can be identified as the face with
the steep sloping contour.
Mount the bars with the countersinks for the M8 fixing bolts facing outwards, so that the captive
nut in the centre is facing in towards the cabinet.
The cabinet assembly can now be attached to the yoke. If the yoke has already been fitted to a
wall or ceiling as part of a permanent installation, this step should be undertaken by two people,
for safety reasons: one to hold the cabinet in place and the other to fit the securing bolts at
either end. If the cabinet is to be suspended from a scaf pole with a clamp, it may be possible
to attached the yolk loop to the cabinet at ground level.
IMPORTANT INFORMATION
All standard safety protocols must be observed when working at height if the fixing point cannot
be reached from the ground.
Note that the each end of the yoke arms has four 10.5 mm holes, 17.5 mm apart. Any pair
of holes may be used; the choice will be determined only by the degree of vertical adjustment
required and how close to the yoke frame the cabinet is preferred to be.