Martela Alku, Руководство пользователя

Страница: 26 / 64

Martela Oyj
Takkatie 1
FI-00371 Helsinki
export@martela.fi
3.1.1 Upward desktop movement
This function enables the upward adjustment of the work surface. To change its position, proceed as
follows:
Press the desktop up button and continue to hold until desired desktop height is reached.
NOTICE
The desktop will continue moving upwards until you release the button or the maximum height is
reached.
3.1.2 Downward desktop movement
This function enables the downward adjustment of the work surface. To change its position, proceed
as follows:
Press the desktop down button and continue to hold until desired desktop height is reached.
3.2 Advanced functions, Manual reset
If a motor (or electronic) has been disconnected from the column, during or after the assembly, a re-
set (homing) cycle MUST be performed. A reset (homing) cycle should be made with emptied table
top.
4. Simultaneously pressing the up and down buttons for minimum of 8 sec-
onds.
5. Press and hold the down button and the table will slowly move the lowest
point possible.
6. The table/stand is ready for normally use.
3.3 CDS (Collision Detecting System)
This table is equipped with a Collision Detection feature designed to avoid possible severe injury due
to pinching. When the table detects a sudden change in resistance (force) equal to approximately 55
kg (120 lb) the CDS will stop the movement of the table and reverse approximately 2,5 cm (1 inch).
CDS works in both directions, i.e. upwards and downwards. Remove the obstacle prior to operating
the table again. The CDS will be active again as soon as the table has been moved (up or down) 8
cm (3,15 inch).
CAUTION
Risk of Pinching .
The Collision Detection System (CDS) is a last resort safety feature and is not designed to detect and
prevent all possible pinching and injuries. The effectiveness of the CDS is effected by the speed of
the table, the location of the table top and the density of obstruction. Even in the event that the CDS is
activated it may not completely prevent injury and all possible safety measures should be taken in or-
der to prevent possible injury.
CAUTION
Risk of Pinching.
The Collision Detection System (CDS) is not enabled during all resets and limit position calibration.