Introduction
•
Do not direct the heads upwards above horizontal.
•
Always operate the sensor with sensor knobs facing downwards.
The security light with sensor continuously scans the detection area and switches the light ‘ON’ when it
detects movement.
This means that whenever movement is detected within the range of the sensor the light will be switched ‘ON’
automatically to illuminate pathways, steps, patios, porches, backyards or areas around the home. While there is
movement within the detection range the light will stay ‘ON’.
The security light with sensor is designed for outdoor use in normal, clean conditions.
BEFORE COMMENCING INSTALLATION
For the best performance we suggest you take into account the following:
Do not face sensor towards direct sunlight.
Best performance is achieved when the movement is across the detection area of the sensor.
light into its own circuit with its own switch.
The recommended mounting height is 2 to 2.5 metres.
Do not install on surfaces which can move or vibrate.
The sensor range is approximately 12m by 150°. This may vary slightly depending on the mounting height and the
temperature.
Always ensure the LED light heads don’t touch the sensor. The heat generated by the heads may be harmful to the sensor
over a period of time. It is recommended to keep a minimum gap of about
30mm
between the heads and the sensor.
Installation Instructions
7
www.martecaustralia.com.au | 02 8778 7500 | [email protected]
Page
7
