Marta MT-1348, Руководство пользователя

Страница: 9 / 11

9

Never use vacuum cleaner for cleaning of cement, glue and plaster. These substances can clog and damage the filter.

Additional suction power regulator is on the handle of the vacuum cleaner.

To prevent motor overheating cleaner do not use vacuum cleaner continuously for more than 30 minutes and always take a break for at least 15 minutes.

After cleaning: switch off the appliance by pressing On / Off button on vacuum cleaner housing. Disconnect the mains plug. By clicking rewind button, wait until the cord is fully
rewound onto the drum inside the unit.

In case of overheating unplug the appliance, wait for 30 minutes, remove all possible obstacles in ingoing airflow holes, then switch on again. The device is ready. If the problem
persists, contact the service center.
CLEANING AND MAINTENANCE

Before cleaning unplug the appliance and let it cool.

Wipe the outer surface of the housing with a soft cloth with mild detergent that does not contain abrasives.

Do not immerse the appliance or power cord in water or any liquid.

Avoid getting water, dirt or any other liquid inside of the appliance.
CLEANING THE DUST BAG:

As the dust container is transparent, it’s easy to monitor the extent of its fullness. Necessarily empty it when the content of the dust bag fills up the visible part.
WARNING: always unplug the vacuum cleaner from the mains before cleaning the dust bag.

After emptying the dust bag it is also recommended to clean the filter.

Remove the dust container and empty it by clicking on the button.

After emptying the dust bag is also recommended, if necessary, clean the filter.
CLEANING THE MICRO-FILTER:

Cleaning the MICRO-filter should be done as it is dirtying.

Use the vacuum cleaner only with the filter fitted. Operation without filters may reduce the suction power and damage the motor.

Always unplug the vacuum cleaner from the mains before cleaning MICRO-filter.

Don’t clean filters in laundry washer.

Don’t use hair-drier to dry filters.

To remove dust container and filter press lock button, pull the handle and remove it, then empty by clicking the button on housing.

Remove MICRO -filter from the dust bag.

Clean MICRO -filter in warm water using soft brush.
NOTE: don’t wash MICRO -filter using soap or any detergent.