MARSHELL DG24800, Руководство пользователя

Страница: 8 / 13

8
5mm inner hexagon spanner 1
8mm open-end spanner 1
Replace the process (as pictures shown at right side):
1)
Turn off the electric ignition key
2) Disassembly the seat and the rear cover (be careful to avoid pulling the cables hard)
3)
Disassembly the power cable, motor output cable and 14p connector plug.
4)
Get out the controller.
5) Installed the new (parameters adjusted) controller
6)
Connect all the plugs (Take care do not connect the power supply polarity wrong, otherwise it will
damage the controller)
7)
Assembly the cover and seat.
3.3 Use and maintenance of the motor
3.3.1 The proper use of motor
1) There is no repairable parts on motor and rear axle itself for the user, so please do not try to open the
controller to repair or change it, otherwise the motor and rear axle may damaged.
2) There is no repairable parts on motor and rear axle itself for the user, so please do not try to open the
controller to repair or change it, otherwise the motor and rear axle may damaged.
3) It is prohibited to let the motor overload or stall for a long time
4) It is prohibited to let the water and other dust into the motor, and the water will get into the motor when the
vehicle drive across more than 15 cm of water, which may permanently damage the motor
3.3.2 Motor maintenance
1) Clean the motor surface frequently, especially motor educe wire(1 time per month)
2) If there have noise when use the motor, please stop use and recover it or change a one.
▲
Attention: Make sure power supply positive and negative polarity is not
reversed when replace the controller, otherwise it will damage to other parts of
the controller or battery.