2 – Installation Process
Page 7 of 28
The Installation process is broken down into a number of steps. You may of course omit any
of these steps if they have already been done:
2-1
Install the Marshall Video Management Software – VMS-16.
2-2
Wire a Marshall PTZ Camera with a RJ45 Cable to the Host Computer.
2-3
Set-up the Camera to work with the Software using the Soft On-Screen PTZ Control.
2-4
Connect the Marshall TKC-100 PTZ Controller with the supplied USB Cable to the
Computer and Install the FTDI CDM Drivers.
2-5
Check what COM Port the TKC-100 has been assigned.
2-6
Set-up the Serial Protocol within the Marshall Video Management Software to match
the TKC-100 chosen settings.
2-7
Set-up the “PTZ Setup” on the TKC-100.
2-8
Test the TKC-100 for Pan, Tilt, Zoom and Focus.
To do this installation you will need the following:
-
Marshall Video Management Software – VMS-16
-
Marshall TKC-100 FIDI Driver
-
Marshall PTZ Camera
-
Windows Computer XP Professional SP2 or above
-
Marshall TKC-100 PTZ Controller with USB Cable
-
RJ45
Cable
Once the Installation and test are complete it is very easy to add or subtract cameras in the
future.
