IOM -
RXTS Series
31
Page 31
Air Conditioner
Features
FAN
button
Press Fan button to select the Fan Speed in four steps-Auto, Low, Med or High. Each time the button
is pressed, the fan speed mode is shifted. For some models, the fan speed can not be adjusted.
7
ECO
button
Press ECO button to initiate this function. This function is available on COOL, DRY, and AUTO (only
AUTO-COOLING and AUTO-FAN) modes. The fan will continue to run for 3 minutes after the compressor
shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is
above the set temperature, at which time the compressor turns back on and Cooling Starts.
4
MODE
button
To choose operating mode, press the MODE button. Each time you press the button, a mode is
selected in a sequence that goes from Auto, Cool, Dry and Fan. The indicator light beside the
button will be illuminated and will remain on once that mode is selected.
The unit will automatically initiate the Energy Saver function under Cool, Dry, and Auto (only Auto-
Cooling and Auto-Fan) modes.
1. To operate on Auto feature :
• When you set the air conditioner to Auto mode, it will automatically select cooling or fan only
operation, depending on what temperature you have selected and the current room temperature.
• The air conditioner will control the room temperature automatically based on the temperature
you set.
• In this mode, the fan speed cannot be adjusted, it starts automatically at a speed according to the
room temperature.
2. To operate on COOL mode :
• Choose Cool Mode to set the cooling function. Use the Up and Down buttons to choose the
desired temperature. When Cool Mode is selected, the fan speed can be adjusted by pressing the
fan button.
3. To operate on Dry mode :
• In this mode, the air conditioner will generally operate as a dehumidifier. Since the conditioned
space is a closed or sealed area, some degree of cooling will continue. On Dry mode, the fan speed
is not adjustable.
4. To operate on Fan Only :
• Use this function only when cooling is not desired, such as for room air circulation or to exhaust
stale air(on some models). (Remember to open the vent during this function, but keep it closed
during cooling for maximum cooling efficiency.) You can choose any fan speed you prefer.
• In Fan only mode, the temperature is not adjusted.
5
6
button
Press or button to change temperature setting.
NOTE: Press or hold either or button until the desired temperature is shown on the display.
This temperature will be automatically maintained anywhere between 60
℉
(16
℃
) and 86
℉
(30
℃
).
If you want the display to read the actual room temperature, see “To Operate on Fan Only” section.”
• The selected time will register in 5 seconds, and the system will automatically revert back to
display the previous temperature setting or room temperature when the unit is on. When the unit
is off, there is no display.
• Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the Auto
Start/Stop timed program.