Marra Forni Traditional, Инструкция по установке и эксплуатации

Страница: 21 / 32

20 21
Problem Solution
1. The flame is blue. 1. Check to make sure that the shutter is closed.
The shutter should remain closed at all times. See
Figure One.
2. The flame is stuck on “High” or “Low” setting. 2. Make sure the blue & black wires are connected
to the gas valve. After you are sure that all wires are
properly connected, test the temp. control dial.
3. The burner shuts itself off. 3. Check the low flame. See Figure 2 for details
on how to do this. You may need to adjust the low
flame regulator.
4. The burner will not light, and there is no flame in
the oven.
4. Is the gas in the oven turned on? Turn the oven
off, and then on again to reset. Make sure that the
combination gas valve is turned ON.
5. Reset light is ON. 5. Check the low flame regulator. You may need
to adjust the low flame regulator, to make sure that
sufficient gas is reaching the oven.
6. The control box will not turn on. 6. This means that no power is connected to the
oven. Check for blown fuses on the back of the
control box. If the control box still does not turn on,
please contact a Marra Forni representative.
7. The display reads “Open.” 7. Make sure that the Thermocouple is plugged into
the control box.
8. The flame is too small or too large. 8. Adjust the high and low flame regulators.
9. The spark igniter does not work. 9. Light the end of a piece of paper on fire and hold
over the burner to light the oven. Use this process
to light the oven until you are able to call Marra Forni
and be issued a replacement burner.
TROUBLESHOOTING
Figure 1.
Shutter is Closed. Figure 2. Regulators
High Flame Low Flame
Low
High