Marquis V65L, Руководство пользователя

Страница: 51 / 59

INSTALL THE CARTRIDGES
Locate and remove the cartridge holder cap on the top lip of the spa. Push
down and turn the holder counterclockwise to unlock. Lift holder out. Snap
the
mineral cartridge into the area of the holder marked “MINERALS” (top
portion), making sure to line up the indentation near the top of the cartridge
with the raised line on the holder. Then snap the
Spa Frog
®
sanitizing car-
tridge or @ease with SmartChlor into the area of the holder marked “BROMINE
or CHLORINE”. Be sure to line up the indentation on the cartridge with the
raised line on the holder. After cartridges are snapped in, return the holder,
push down, and then turn clockwise to lock into place. Replace the cap.
CAUTION: Hand-tighten only; avoid over tightening; avoid bending the
holder to help prevent damage to the holder. Damage caused due to im-
proper removal or installation of chemical cartridge holder is not covered
under the warranty. Cartridge holder is warranted to be free from defects
at time of delivery of spa. Chemical cartridge holders do not qualify for labor
coverage. These parts can be purchased or exchanged under warranty at
your authorized Marquis
®
dealer.
REMOVE THE CARTRIDGES
Reverse above procedures to remove cartridges.
*The built-in sanitation system is not available in some international markets.
See your authorized Marquis
® dealer for recommended alternate water
treatment method.
WATER CARE REGIMEN
Marquis SpaCare™ products are classified by easy to follow usage
guidelines. The information below indicates whether the product should
be used daily, weekly, monthly, when filling, or as needed – if special water
conditions arise.
DAILY
Sanitizer – You must keep a residual of preferred sanitizer in the hot tub.
Maintain 1 - 2 ppm of bromine or .5 - 1 ppm of Smartchlor chlorine at all
times.
WEEKLY
Spa Shock
Sanitizer combines with bacteria and neutralizes sanitizer/bacteria on
contact. However, the used sanitizer/bacteria particle is still present in the
spa water. Used sanitizer in the water emits an odor and causes cloudy
water. To oxidize, or rid the spa of this used sanitizer, you must shock the spa
once a week for bromine or once a month for @ease with Smartchlor. For
best results, and to protect your spa cover leave the spa cover open for a
minimum of 20 minutes after shocking the water.
NOTE: Additional shocking may be necessary if the spa is under heavy
use.
SPA CARE & ENJOYMENT GUIDE
51