4
Features
Rear Panel
1.
Power In:
Use a standard power cable
(included) to connect this input to a power
outlet.
2.
Fuse:
This compartment holds the fuse.
Before
cleaning or replacing the fuse,
disconnect Gesture Spot 100 from its
power source
. Use a screwdriver or other
tool to remove the compartment (do
not
pull it out by the tab only). Replace the fuse
only with a new fuse with the same rating
(
F2A, 250 V
).
3.
Power Out:
Use a standard power cable to connect this output to an additional fixture. This
connection will supply power to the additional fixture when this one is connected a power outlet.
Please see
Setup
>
Linking
>
Power
for information about linking multiple fixtures.
Note:
On models sold in the USA, this will be a standard “Edison” (NEMA
®
) connection. On other
models, this will be a standard IEC connection.
4.
DMX In:
Use a standard 3-pin DMX cable to connect this input (
A
) to your DMX controller or (
B
)
to another fixture that will pass DMX data through it to this one. Gesture Spot 100 receives DMX
data over this connection. Please see
Setup
>
Linking
>
DMX
for information about linking
multiple fixtures.
5.
DMX Out:
Use a standard 3-pin DMX cable to connect this output to an additional fixture.
Gesture Spot 100 sends its data to an additional fixture over this connection. Please see
Setup
>
Linking
>
DMX
for information about linking multiple fixtures.
Front Panel
6.
Display:
This display shows messages and
values indicating the fixture’s current status.
7.
Menu:
Press this button to access Gesture
Spot 100’s menu.
8.
Up:
Press this button to select the next-
highest menu option or to increase the
value by 1.
9.
Down:
Press this button to select the next-lowest menu option or to decrease the value by 1.
10.
Enter:
Press this to confirm your current selection or value.
1
2
3
4
5
6
7 8 9
10
