Marport M6 Mx, Руководство по обслуживанию

Страница: 51 / 79

M6 - Mx computer System | V2 | Installation
Adding Temperature Data from the Hydrophones to the System
You can add the hydrophone to the receiver as a sensor in order to display in Scala/Scala2 the
temperature of the water surface.
Before you begin
Important: In order to receive temperature data, make sure the hydrophone is connected
to an NTC input on the receivers or is connected using an NMEA converter junction box. See
Connecting the Hydrophone to the Receiver on page 49 for guidelines.
Procedure
1.
From Scala/Scala2, click Menu > Expert Mode and enter the password
copernic
.
2.
Click Menu > Receivers .
3.
Right-click the IP address of the receiver at the bottom of the page, then click
Configure Receiver .
4. From the left side of the receiver page, click Sensors .
5. Under Add Sensor Product :
a) Select Hydrophone in the Product Category menu.
b) In the Product Name menu, select NMEA temperature if using an NMEA converter junction
box, or NTC temperature if the hydrophone is connected to an NTC input.
c) In Hydrophone Location , select the number of the receiver's port on which the hydrophone
is connected.
d)
Click Add Sensor .
Results
The water temperature is displayed in Scala/Scala2, in the control panels, under Sensors
Data / Mx .
| 50