10
MARMITEK
4.2. Programming the TV, VCR , DVD, SAT and AUX modes
You can program the TV, VCR , DVD, SAT and AUX modes in three different ways.
1. When your equipment is one of the following six brands (Philips, Sony, Thomson,
Saba, Grundig, Nokia) you can use the Brand Search method. Use
method A
in this
case.
2. Are you using another brand of equipment ? If so, find your brand in the code book,
and use
method B
to program your PC Control.
3.
If the above two methods are not working, you can use
method C
and search for
the codes manually or automatically.
Note:
you can dedicate any appliance (TV, DVD, SAT...) to the VCR, DVD, SAT,or AUX keys.
Method A: Programming using the Brand Search method
If your brand is listed hereafter, you have the possibility to use the brand search method
(faster than the "manual" and the "automatic code search").
Brand
Code Brand
Code
Philips/Radiola 1
Telefunken/Saba/Normende
4
Sony/Panasonic/JVC/Sharp
Akai/Toshiba/Daewoo
2
Grundig/Blaupunkt 5
Thomson/Brandt 3
Nokia/ITT
6
1.
Turn on the device you want to control.
2.
Press and hold
SETUP
(4) until the LED indicator (2) lights steadily. Release
SETUP
button.
3.
Press the mode button (3) that matches the equipment you wish to control. The LED
(2) blinks once.
4.
Enter the code corresponding to your brand, point the PC Control Remote in the
direction of your equipment, press
(9) once only. Continue to point the PC
Control Remote at your equipment until the equipment changes channel (the remote
control sends an IR signal every second. Please wait until your equipment reacts).
When your equipment does react, press on the key
--/-
(14) to confirm. If you
accidentally miss the code, you can stop the autosearch by pressing
Channel-
(9) and
by repeatedly pressing this key return to the right code. Press
--/-
(14) to confirm.
Method B: Programming using the 3 Digit Code Tables
1.
Make sure your equipment is switched on (for example TV).
2.
Press and hold the
SETUP
(4) key until the LED indicator lights continuously. Release
the
SETUP
key.
3.
Press and release the mode key (3) of the device you want to control (for example TV).
4.
Enter the 3 digit code from the Code Book by using the key pad (11). The LED (2)
turns off after the last digit is entered. If you entered a wrong code the LED blinks for
3 seconds and then goes off. You have to repeat from step 2.
5.
Point the remote in the direction of your TV and press the POWER button (1). Your
device should turn off. Check other functions (for example for a VCR FF or REW, etc.).
If certain functions are not responding, this indicates that the entered code is not the
correct one. In that case repeat the above procedure with the next corresponding
code of your brand.
6.
Repeat this procedure from step 1 for the other equipment you want to control (VCR,
DVD, SAT).
