SAFETY PRECAUTIONS
• To prevent short circuits this product should only be used indoors and only in dry rooms.
Do not expose the components to rain or moisture. Do not use near a bath, swimming
pool etc.
• Only connect MT10 to the mains after you have ensured that the mains voltage matches
that shown on the type plate. Never connect the mains cable if it is damaged. In the event
of damage please contact you supplier.
• Never expose your system’s components to extremely high temperatures or bright light.
• Never open the equipment. Parts of the equipment have a very high voltage. Repairs or
maintenance should be undertaken by qualified service personnel only.
All warranties are invalidated in the event of incorrect use, unauthorised modifications or
repairs. Marmitek accepts no responsibility in the event of incorrect use of the product or if it
is used other than for the intended purpose.
1. INSTALLATION
Place a 9V block battery in the battery compartment on the underside of the timer. Plug the
adapter into a wall socket. Set the HouseCode (A…P) by turning the dial [3] on top of the
unit using a screwdriver or coin.
N.B. If the battery is empty, the LED text “battery low” will light up [13].
SETTING THE CLOCK
Set the mode selector [1] to “SET CLOCK”. Set the time by pressing the <TIME> buttons [2].
Keep an eye on the “PM” [14] light. When the “PM” LED is off, the time is AM, when the
“PM” LED is on, the time is PM.
2. MANUAL CONTROL
Marmitek X-10 modules can be manually controlled by pressing the 1-5, 2-6, 3-7 and 4-8
buttons [4]. Depending on the setting of the selector 1-4 <> 5-8 [10], the ON/OFF buttons
control modules 1 through 4 OR 5 through 8.
Press the ON side of a button to activate a module [4].
Press the OFF side of a button to deactivate a module [4].
To dim a lamp connected to a Lamp Module, you must first press the ON side of the button
with the same UnitCode as the module and then “Bright <> Dim” [5].
SWITCH ON ALL LIGHTS
You can switch on all the lights connected to any of the Lamp Modules with one press of a
button. Press “ALL LIGHTS ON” [6] to switch on all the Lamp Modules with the same
3
MT10 BEDROOM X-10 CONTROLLER
Содержание MT10 BEDROOM X-10
Страница 2: ...2 MARMITEK 1 2 3 4 5 6 9 8 7 10 11 12 14 13 MT10 BEDROOM X 10 CONTROLLER BATTERY LOW ...
Страница 6: ...6 MARMITEK 1 2 3 4 5 6 9 8 7 10 11 12 14 13 MT10 BEDROOM X 10 CONTROLLER BATTERY LOW ...
Страница 10: ...10 MARMITEK 1 2 3 4 5 6 9 8 7 10 11 12 14 13 MT10 BEDROOM X 10 CONTROLLER BATTERY LOW ...
Страница 18: ......
