Programming the X10 address and the various options.
The chart below shows the various possibilities to program the
MicroModule LWM1.
Factory defaults
Programmable
Command
Light blinks
Address A1
Address A2 .. P16
2x Address
2x
Doesn’t respond to
Responds to
2x All Lights On
6x
“All Lights On”
“All lights On”
Doesn’t respond to
Responds to
2x All Off
8x
“All Off”
“All Off”
Connected switch is a
Connected switch is a
2x Bright
12x
2-way momentary switch
1-way momentary switch
For programming the Marmitek X10 address and options you will
be able to use any Marmitek X10 controller or remote control,
apart from the CM11 computer interface.
For the following explanation we used a Marmitek 8-in-1 remote
control to program the preferred settings (when you use an RF
remote control like the Marmitek 8-in-1, then a TM13 Plug-in
Transceiver is required to convert the RF signals to the X10
commands through the power line).
Sample 1. Program the Marmitek X10 address E4:
• Setup your remote control (see manual 8-in-1) and the TM13
transceiver to house code E.
• Start with the MicroModule in setup mode.
• Press the Marmitek X10 button (marked with the symbol of a
house) of the 8-in-1 remote control and then press button 4.
• Press the “ON” button 2x (= ).
• The MicroModule responds by blinking the LED twice.
• The address E4 is programmed.
• If you wish to program more options, you have to make sure
the module remains in setup mode.
Sample 2. Program the function “All Units Off”.
• Make sure you program the required Marmitek X10 address
12
© MARMITEK
20160_20070423_UG_LWM1 26-04-2007 16:28 Pagina 12