Marmitek EASYTOUCH 35 -, Руководство пользователя

Страница: 11 / 80

11 EASYTOUCH 35
4. Release Setup key.
5. Press and release the Touchscreen "CODE" Key.
6. Display will show the Mode Setup Screen. Press and release desired Mode key (TV,
VCR, SAT, etc.) on the rubber keypad.
7. Display will show the Code Setup Screen. Enter the 3 digits of the Device Code from
the Library Code Tables. For a valid Code, the LED blinks off after the last digit is
entered. For an invalid Code, the LED will flash rapidly three times before going off.
In both cases, the display will return to the Main Setup Screen.
8. Press and release the Touchscreen "EXIT" key to return to normal operation.
9. Point the remote in the direction of your TV and press the POWER key. Your device
should turn off. Check other functions (for example for a VCR: FF or REW etc.). If certain
functions are not responding this indicates that the entered code is not the correct one.
In that case repeat the above procedure with the next corresponding code of your brand.
10. Direct Library Code entry now complete
11. Repeat this procedure for the other appliance you want to control (TV, VCR, DVD,
SAT, CD, CBL, AUDIO and Marmitek X-10 Home Control)
Method C: Programming using the Manual Code Search-method
If you are unable to find your code either in the Code Tables or by using the Brand Search
Method, you can try all the available codes for the appliance using the Manual Code
Search.
1. Make sure your appliance is switched on. If not switch it on manually.
2. Activate your ET35 remote by touching the screen
3. Press and hold Setup key until the LED remains on (this occurs after approximately
2-3 seconds) and display shows Main Setup Screen.
4. Release Setup key.
5. Press and release the Touchscreen "CODE" Key.
6. Display will show the Mode Setup Screen. Press and release desired Mode key (TV,
VCR, SAT, etc.) on the rubber keypad.
7. Display will show the Code Setup Screen. Press and release the Touchscreen
"SEARCH" Key.
8. Display will show the Search Setup Screen. Press the Touchscreen "UP" key (or Power
or Play) repeatedly until the Device to be controlled changes channel. Alternatively,
you can use the Channel Up key. Press and release the Touchscreen "OK" (or Mute)
key to install the Code. Display will return to the Main Setup Screen.
If you accidentally overshoot the Code required, press the Touchscreen "DOWN" or
Channel Down to backtrack through the Library to return to the correct code.
Pressing the Touchscreen "UP" key (or Power or Play) will change direction to forward
again.
ENGLISH
20055_20061108_UG_EasyTouch_35_touchscreen_remote 09-11-2006 10:22 Pagina 11