MOUNTING INSTRUCTIONS:
When riser is assembled and deck has been prepped
1. Lift assembled riser onto sled deck, with deck sides in the fully open position, align holes in front
leg (2) and rear deck ramp pad (2) with 4 holes in sled deck, 2 fronts close to headache rack and 2
rears close to rear of deck.
NOTE: if holes are not already drilled in deck, refer back to steps #1, 2, & 6 of Installation Instructions
2. Install 2
–
5 ¼” bolts with 2 flat washers and nyloc (do not tighten yet).
3. Position the 4-deck ramp leveling
spacers under the rear deck ramp pads. 9” pieces on the bottom
18” pieces on top of the 9” piece (e
ach side). This is to level under the pad. See pic below.
