Marlon 350E, Руководство по обслуживанию

Страница: 12 / 18

TABLE ADJUSTMENTS
Now that you have the correct blade configuration ready for the coil
diameter you are crimping you need to adjust the table height and cutter
head spacing (width) for your book. Refer to page 13 for table adjustment
details.
1.)
Loosen the two clamp knobs on the left-hand book guide; position the
guide so your book will be approximately centered on the machine. Re
tighten the two clamp knobs.
2.)
Using the same procedure position the right-hand book guide so it just
touches the right edge of the book. The book should lay flat on the table
between the book guides and be able to slide in and out, but not side to side.
3.)
Use a #3 Phillips screwdriver to loosen the two bolts located under the
two access holes in the top cover. The two cutter heads will now be able to
slide from side to side. Slide the two cutter heads so the cutter blades are
close to the correct loop of the coil at each end of the book.
4.)
Make a rough adjustment on the table height by turning the two table
height knobs. Turn the knobs clock-wise to lower the table and counter
clock-wise to raise the table. Adjust the table height so the coil in the book is
in the center of the cutter blade assembly on both sides. The right side of the
table will always be adjusted higher than the left side.
5.)
Adjust the two cutter heads from side to side until the coil in the book
slides into the cutter blades at the correct loop of the coil on each side of the
book
6.)
Make a finer adjustment to the table height so the coil in the book is
properly positioned in the center of the cutter blades.
7.)
Make your final cutter head adjustments side to side if needed and then
re tighten the two bolts under the access holes of the top cover using the #3
Phillips screwdriver.
8.)
Test crimp a book by depressing the foot pedal.
9.) Make your final table height adjustments if needed. Then repeat steps #8
and #9 until the desired crimp is achieved.