• To pierce the tubing, turn the Valve
Handle fully clockwise (inward). A small
amount of water may escape from the
outlet until it is fully pierced.
When you feel the Valve Handle firmly
seated in the clockwise direction, the cop-
per tube is pierced and the valve is
closed.
2b.To install on (hard) Steel or Brass Tubing
supply line.
• The supply line should now be drained.
Use a battery powered or properly
grounded drill to avoid shock hazard.
• Drill a 3/16" hole in the supply line; (do
not drill through the opposite wall).
• Turn the handle to expose the lance no
more than 3/16" beyond the rubber gas-
ket.
• Place the body of the valve over the hole
so that the lance fits into the hole.
• Assemble and tighten the brass screw.
• Turn the Valve Handle clockwise (inward)
until firmly seated. The valve is closed.
3. With the Feed Water Saddle Valve closed,
open the sink faucet and the water supply
and allow the water to run for a few min-
utes to flush any debris caused by the
installation.
•Close the faucet and check the Feed
Water Saddle Valve for leaks.
C. Drain Clamp Installation
Choose the drain outlet location per Sec. III,
C.5, page 5.
The following are instructions for discharging
into the sink drain pipe. (Refer to Fig. 1, page
1.)
1. Position the Drain Clamp on the sink drain
pipe above the drain trap. Allow room for
drilling. Tighten securely.
2. Use a battery powered or properly ground-
ed drill. Using the Clamp port as a drill
guide, drill a 7/32" hole through the wall of
the drain pipe. Do NOT penetrate the oppo-
site side of the pipe.
3. Locate the 3/8" Black Drain Tubing which is
shipped loose in the box.
NOTE:
When cutting the polytubing make
clean, square cuts, failing to do so could result
in poor connections and possible leaks.
Drain Pipe
1/4" Screw
Drain Clamp
Front Plate
Insert
Compression
Nut
Black Drain
Tubing
1/4" Nut
Drain Clamp
Back Plate
3/8" DRAIN CLAMP ASSEMBLY
Figure 4
