Marlo Incorporated RO-14C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 20

LONG REACH AIR GAP FAUCET
WITH " CONNECTOR
Figure 2
3. Assemble and attach the Faucet (Refer to
Fig. 2 above.)
• Assemble the Body and Spout by remov-
ing the plastic shipping plug from the
Body and then firmly pressing in the
Spout.
• In the following order, place the Face
Plate (Escutcheon) on the 7/16" stud.
• From the top of the counter place the stud
through the mounting hole.
• From the bottom of the counter top, in the
following order, assemble the steel Slotted
Washer, the Plastic Spacer (with open
end upwards), the 7/16" Washer and the
7/16" Hex Nut.
• To the end of the 7/16" stud screw on the
1/4" Polytube Quick Connect Fitting. Once
snug by hand take a pair of pliers and
tighten the fitting an additional half turn.
Don’t over tighten.
• Rotate the Spout and Body into position.
Align the Split Washer and the Spacer to
allow access to the Hose Barbs, and tight-
en the Hex Nut while holding the faucet in
alignment with a padded Crescent
wrench. Do not over tighten.
B. Feed Water Saddle Valve Installation
Decide on location. Do NOT connect to a hot
water feed line. If you are not sure of the sup-
ply, run the hot water and feel the supply pip-
ing. Water over 100˚F may cause permanent
damage to the R.O. Membrane. (Refer to Fig.
3 below.)
FEED WATER SADDLE VALVE
Figure 3
1. Shut off the water supply and drain the line.
2a.To install on (soft) Copper Tubing supply
line:
• Turn the Handle of the Feed Water
Saddle Valve counter clockwise (outward)
until the lance does not protrude from the
gasket. It may have to be pushed in.
• Assemble the Feed Water Saddle Valve
on the tubing.
–for 3/8" OD tubing use the back plate side
with the small groove to prevent distortion
of the tubing.
–for larger tubing (up to 5/8" OD) use the
large groove of the back plate.
• Assemble and tighten the brass screw.
Spout
Plastic Shipping
Plug (Remove)
7/16" Stud
Face Plate
(Escutcheon)
Mounting
Surface
Plastic Spacer
7/16" Washer
7/16" Hex Nut
1/4" Polytube
Quick Connect
Fitting
1/4" Blue Polytube
From Outlet on
Manfold
CL
Slotted Washer
Air Gap Window
Critical Level
Line
Reject Outlet For
Drain Clamp Line
Reject Inlet For
Manifold Drain Line
Cold Water
Line
Saddle
Valve
Handle
Insert
Plastic
Ferrule
Tubing To
Manifold
Inlet
Compression
Nut
Tightening
Screw
Reversible
Back Plate