24
Remote Start Operation and Feature Programming
Voltage Detection Additional Programming
If you have previously selected Voltage Detection, you may be required to program 2 additional features as enclosed.
Feature 1: Crank Detection Level Programming
Turn the ignition switch from the
OFF position to the ON position
three (3) times leaving it in the Off
position the third time.
OFF
ON
3X
Step 1
Before 15 seconds has passed, push
and release the valet switch nine (9)
times then push the valet switch a
tenth time and hold it down until five
(5) short chirps/beeps + one (1) long
chirp/beep is heard then release it.
9X + 1X (Hold)
Step 2
Press the ( ) button twice on the
transmitter to start the vehicle. If
everything is correct, the engine will
crank and fire without over-running
or under-running the starter.
Note:
Let engine run for 10 seconds
or more to ensure proper operation.
Step 3
SET
Bi
6
Remote Start Operation and Feature Programming
Tachometer Detection Programming (continued)
Feature 2: Crank Detection Level Programming
If the engine cranks too long you may need to adjust
the crank detection level. Press the ( ) twice to stop
the engine from running. Press the ( ) button on the
transmitter to change the crank detection level from Hi
to Low. You will hear 1 chirp/beep to indicate the
feature has been changed to the Low selection.
Press the (
) button twice on the transmitter
to start the engine by remote. Setting the crank
detection to Low should have solved the over-
cranking problem.
Step 9
Step 10
Note:
If the crank detection level is set to High and the engine still will not start consistently due to a short crank
time, it is suggested that you re-program the unit to use another type of detection (either voltage or timer) to get
the engine to start consistently.
4/5/6
5
4
C
Bi
6
Bi
6
M11A-IM 3/8/05 3:43 PM Page 24
