Hints for operation
• The mains voltage must match that shown on the type-plate of the tool
• Check the maximum distances for the safety equipment.
• Do not run the tool for long periods at a time. To avoid overheating the tool should not be kept
switched on for longer than 15-30 minutes at a time. Allow the tool to cool down between each
operations.
• Press the work-piece carefully against the grinding disc. using adequate pressure. Remember that
the work-piece gets very hot during grinding. Cool the work-piece form time to time by dipping it
in cold water.
Maintenance
• Remove grinding dust regularly from the housing and moving parts with a brush, or wipe the
housing and moving parts with a damp cloth. Do not use solvents! Afterwards allow to dry
thoroughly.
• Wheel replacement: If you must replace a wheel be sure to obtain one with a safe rated speed at
least as high as the no load speed marked on the nameplate and with right disc size.
