MARKS USA i-Que Metro Series, Руководство по программированию

Страница: 15 / 20

Reset the i-Que back to factory default
Unplug the batteries and place aside
Find the Black And Yellow cable
Using a reset wire (small piece of wire or paper clip)
short the two wires of the black and yellow cable together
(place the wire from the one hole on the connector to
the one next to it, thus making a loop)
With the reset wire in place reinstall the batteries.
The LED should go RED then Green, You should hear the lock relock.
Remove the reset wire and reassemble the batteries and cover on to
the housing assembly.
The lock is now reset. You are now at the point of set up.
Install the LOCK ID and GGM code. (See Page 2)
Yellow and Black
Page 11
Red and Black
Reset / Key Switch Black And Yellow
(factory Installed option)
This option will monitor if a key is used
to open the lock.
For Resetting the i-Que see below
Motor cable
Red and Gray lines to the
motor connector
Power RED (+) and Black (-)
6 Volts DC. Connects to the supplied battery pack
Blue and Black
Request to Exit switch.
(Factory installed option)
Cylindrical model shown (IQ1K). Please note: The Mortise (IQ2K) Tubular (IQ3K)
and Exit device interface (IQ7K) will not have the motor leads. These leads will be
connected inside the front trim by the factory.
•The lock is now reset. You are now ready to initialize the lock.
Create the
GGM code (See Page 2.)
Cable Gard