13
www.markilux.com
3. Awning installation
1
4
2
3
5
6
6
7
1. Unpack awning from the box (pay
attention to marking "top"). Do not
remove the protective foil (1) of the front
profile and the transport belt fixings (3
- adhesive strips, 4 - Styrofoam wedges)
from the guide tracks (2).
2. Fit the cassette (5) to the bottom
fixture bracket (6) you have already
fitted.
3. Tighten the SW 5 allen key size
cheese-head screws in the clamp plate
(7) of the bottom fixture brackets (6).
9
8
2
10
2
13
12
11
4. Unscrew the countersunk head screw
(8) at the left side cheek and remove the
inspection cover (9).
5. Place the left guide track (2) the on
track bracket (10) and clip it in place; do
not screw it down tight yet.
6. Slide the guide track profile (2) about
2 to 3 cm over the rollers of the front pro-
file bogey onto the end cap (11).
Remove the tape holding the drive belt
in place (adhesive strip) from the guide
track profile. The lug-end of the drive
belt (12) must be fed over the belt roller
(13).
2. Fitting the brackets (e.g. bottom fixture)
1
MA
MA
1
MA
2
2
MA
1. Hold the cassette bracket
(1) in place, mark the drill
holes at axial distance from
one another and drill (M8
screws).
Attention!
All brackets
must be aligned with each
other!
2. Fix the bottom fixture
cassette brackets in place(1).
3. Hold the track brackets (2)
in place [from H = 401 cm,
also (3)], mark the fixing
points at axial distance from
one another and drill the
holes (M8 screws).
Attention!
Observe
respective figure under
chapter 1.3.1 to 1.3.3!
4. Fix the track brackets (2) in
place. Measure all brackets
diagonally!!