2-1
18"
457mm
1 1"/4
32mm
14 1/2"
368mm
2 1/4"
57mm
10"
254mm
12 1/2"
317mm
MARK (4) CORNERS
ON COUNTER
Figure 2-1
Front of Kettle
Section 2 INSTALLATION
2.1 INSTALLATION
a) Position kettle on counter allowing sufficient rear clearance from wall to tilt freely and completely without obstruction.
b) Mark (4) corner locations of kettle base, as shown below.
c) Remove kettle from counter and locate position of 4 holes as per above drawing. Drill four 7/6" diameter holes.
d) Apply a continuous bead of Silastic or other equivalent sealant along the complete perimeter edge of the kettle base.
e) Use 5/16 - 18 x 1 1/2" Hex Cap Screws with suitable flat washers to bolt down.
f) Wipe off excess sealant.
g) A Control Box with power supply equivalent to Electrical Rating of kettle should be located conveniently nearby.
h) A waterproof electrical connection for power supply to console housing must be provided.
i) Ground kettle to terminal provided inside console housing.
j) Turn power ON and check for proper operation. (See Section 3).
Содержание FT-20CE
