6
HMI-EC (06 99 150)
5.4. MAIN SETTINGS
No.
Description
Operation button
1
Heating mode:
Operation of single heater coils sections
Operation of two heater coils sections
Function A1
[^] or [v]
2
Calendar-based work:
Yes
;
No
Function AE
[^] or [v]
3
Operating mode:
heating:
;
ventilation
;
h ventilation
+
;
Function A3
[^] or [v]
4
Temperature display:
ROOM
(current temp.),
SET
(set temp.)
EXT
(based on external temperature
sensor)
Function A1
[^] or [v]
5
Day of the week
Hold
[Set]+[v]
6
Hour, minute
Hold
[Set]+[v]
7
Screen lock
Hold
[v]
8
Door close/open
n/a
Explanation of the operating modes:
Speed I: Programmable value in the range of 15-80%.
Speed II: Programmable value in the range of 15-90%.
Speed III: Programmable value in the range of 15-100%.
Press to change the fan speed.
The values of the individual gears can be set from the advanced
settings A: function A5, A6 and A7.)
5.5. TIME SCHEDULE SETTINGS
5.5.1. TIME/DAY SETTING
You can set the present time and day on the controller. To do it,
press and hold the [Set] button and the arrow down button. The
controller will enter the time/day settings mode allowing you to set
present time and day of the week.
5.5.2. SCHEDULE SETTING
Having the controller in active mode, press the [Set] button and
hold it for 5 seconds. The controller will enter the time (weekly)
schedule settings mode.
Use the [Set} button to toggle between schedule functions [^]
and [v] buttons to change the value.
The weekly schedule can be set for each day of the week and 4-
time intervals for each day.
Your schedule settings will be demonstrated on the graphical
time chart like on Figure 5
6. PROGRAMMING MODE
6.1. ADVANCED SETTINGS, SECTION A & B
To enter the advanced settings A of this controller, press and
hold the [
] button for 5 seconds at the deactivated controller.
Toggle between parameters using [Set] button. Change the value
or settings of selected parameters using [^] and [v] buttons. After
changes are applied, leave the settings mode by pressing power
button of the controller. Your settings will be saved automatically.
For advanced settings A group, the following parameters can be
modified:
No.
Function
Set point
IP
Communication Modbus RTU -
address
1 ... 254
A0
Modes of automatic operation:
room [0], door [1], door+room
[2]
selection [0, 1, 2]
A1
Regulation of the heating power
level:
without heating [0], first level [1],
second level [2], third level [3]
Selection [0, 1, 2, 3]
Figure 5 - Time schedule chart
