Mariner Mercury 105/140 JET, Руководство по обслуживанию

Страница: 769 / 797

90-824052R3 JUNE 2002 ATTACHMENTS/CONTROL LINKAGE - 7-9
Steering Cable Mounting Tube
Installation
IMPORTANT: Spacers (b) must be installed
between outboard swivel bracket and mounting
bracket for steering cable mounting tube to
provide proper spacing between steering cables.
Secure mounting bracket for steering cable
mounting tube on to swivel bracket of outboard.
b
a
c
28163
c
d
a - Mounting Bracket for Steering Cable Mounting Tube
b - Spacer (2) – Used on Earlier Models
c - Locking Retainer (2)
d - Bolts (4) - 7/8 in. (22mm) Long - Torque to 100 lb. in.
(11.5N·m), then Bend Corner Tabs of Locking Retainers Up
and Against Flats on Each Bolt
WARNING
Locking retainer corner tabs, MUST BE bent up
and against flats on each bolt that secures
mounting bracket for steering cable mounting
tube to outboard swivel bracket to prevent bolts
from turning out.
Install steering cable mounting tube into mounting
bracket with 2 adjusting nuts and 2 locking tab
washers. Verify longer threaded end of tube is toward
starboard side of boat.
Temporarily adjust tube so that longer threaded end
of tube extends out the same distance as the
outboard tilt tube. Do not tighten adjustment nuts at
this time.
d
c
a
b
51891
a - Steering Cable Mounting Tube (End of Tube with Longer
Threads Toward Starboard Side of Boat)
b - Mounting Bracket
c - Locking Tab Washers (2)
d - Adjustment Nuts (Flats of Nuts Facing Toward Locking Tab
Washer)
Installing Steering Cables
IMPORTANT: Lubricate inside of outboard tilt
tube, inside of steering cable mounting tube and
rubber O-ring seal (located in outboard tilt tube)
with Quicksilver 2-4-C w/Teflon before installing
steering cables.
Lubricate inside of outboard tilt tube and inside of
steering cable mounting tube with Quicksilver 2-4-C
w/Teflon. Verify rubber O-ring seal (a) (located in
outboard tilt tube) is lubricated.
a
51890