10
There are three mounting holes in the back of the Display for attachment of the ball
mounting plate. Take care not to strip screw holes or over tighten. (Figure 3)
I
Because of various
surface substrates where the Display is to be mounted, the installer provides screws
to mount the other ball.
•
Note location of the three mounting holes on ball mounting plate (Figure 3)
•
With three (3) M4 x 10 counter-sunk stainless screws (Figure 2) attach mounting
plate to back of the unit. (Figure 1)
•
Mount second ball mounting plate on surface where Display is to be installed
•
Insert each ball into RAM arm
•
Lightly tighten arm around balls using T -knob on arm (Figure 1, 3)
•
Adjust Display to viewing preference, and
•
Fully tighten T-knob to hold Display in position.
Flush Mount with Optional Bezel
With the Flush Mount Bezel, the MPC-ML2xxRF
-
ing surface; Installer is responsible for providing hardware for this installation.
The mount diagram of Flush mount bezel is on the MarinePC website (www.MarinePC.com/
support). When placement site has been decided, it is recommended installer use
these measurements when cutting the opening for the Display’s installation.
Note the locations of milled holes in Flush Mount Bezel. Drill corresponding holes into
substrate where Display is to be mounted.
Take care not to strip screw holes or over-
tighten as the enclosure is aluminum.
CAUTION!
Panel Mount
Panel m
order; the ball-and-socket mount system will not be
included in the shipping box. (Figure 4)
For installation there are four tapped M6 mounting
holes on four corners of Display’s rear panel. Mounting
hardware is provided by the installer. Suggested hard-
ware includes (4) M6 stainless steel threaded studs,
7.6 cm (3” long), four (4) Nylock self-locking nuts and
It is recommended installer refers to mount drawings on the MarinePC website
(www.MarinePC.com/support)for exact measurements of Display’s rear panel pod. These
drawings should be helpful when installer cuts the required opening for Panel Mount
installation.
f igure 4
MPC-ML2R-UM 4/2014
