height adjustment warnings
marimba cleaning
moving the marimba
sagging bars
051214 - REV. A
PAGE 10 0F 11
• Always adjust the height of the marimba with rails, resonators and bars installed.
• Release the levers one end at a time.
• Always keep marimba ends at equal heights.
• Do not release the end levers at the same time.
USE A SOFT COTTON RAG OR TOWEL DAMPENED WITH WATER ONLY.
DO NOT USE FURNITURE POLISH on your marimba!
Most of this type of product contains silicone, which will damage the finish and
contaminate the wood.
THE MARIMBA SHOULD ONLY BE LIFTED BY THE END FRAMES.
• Lifting by the rails will cause the rails to come out of their slots.
• When the marimba is moved, pass VERY SLOWLY through
doorways, over doorjambs, electrical cords, and uneven surfaces.
With time, the natural or accidental bars
may sag over the length of the marimba.
CAREFULLY REMOVE THE BARS
THAT ARE SAGGING.
• Lift out the rail that is no longer level
and fold the rail to expose the stainless
steel leveling screws.
• Turn ONE of the screws about an
eighth of a turn from its present
location.
leveling
screws
Replace the rail and check it again. Reposition the bars as before.