NOTE:
Installation must be in compliance with the National Electrical Code and
your local electrical and plumbing codes.
1.
Do not install the unit in a room where there is a chance of freezing.
2.
DO NOT install this water heater near tinder, volatile or flammable substances,
or near a strong magnetic field. The unit must only be mounted in a VERTICAL
position near the water fittings.
3.
Mount the unit to a flat section of wall, well away from any potential water
splashes or spray. Be sure to use wall anchors, or screw directly into studs.
4.
Position the unit upright with all plumbing connections at the bottom of the unit.
5.
Make sure the water heater and all fittings are complete and intact.
6.
Make sure that the main power supply, water pressure, ground, amperage,
voltage, and wiring meet all standards.
7.
The water heater must be connected to a properly-grounded, dedicated branch
circuit with the proper voltage rating. The ground must be connected to the
“ground” at the circuit breaker panel.
8.
This water heater MUST be permanently connected to a fixed and dedicated
circuit breaker. If the heater will be unused, switch off the circuit breaker.
INSTALLATION
Locate an appropriate place on a section of wall that meets all safety and
installation requirements.
10
11
Fig. 05
Front and back of the appliance (please see Fig. 05).
Remove the screw which fixes the bracket on the back of the appliance (Fig. 06).
Remove the bracket from the appliance (Fig. 07).
Fig. 06
Fig. 07
Содержание ECO240
Страница 1: ......
