The installation must be in compliance with the National Electrical Code, your local
electrical and plumbing codes.
1. Make sure the appliance is intact, and the fittings are complete.
2. Please make sure the main power supply, water pressure, grounding condition, ammeter
and wire reach the standard of installation requirement.
3. The appliance must be connected to properly grounded dedicated branch circuits of proper
voltage rating. Ground must be brought to the "ground" at the circuit breaker panel.
4. This appliance MUST be permanently connected to the fixed circuit breaker. If you do not
use the heater, please switch off the circuit breaker.
5. DO NOT install this appliance near tinder or a strong magnetic field place. The unit must
only be assembled in a VERTICAL position near by the water fittings. Please try the unit after
getting the water flow.
PRODUCT INNER STRUCTURE
INSTALLATION GUIDELINE
Down
On/Off
Up
Temp. Sensor
Heating Chamber
Flowmeter
Terminal blocks
L2
L1
E
Display Screen
Bottom Panel
Control Board
09