MARENIUS ELEKTRONIKUTVECKLING AB | BOX 5086 | SE-42605 VF, SWEDEN | TEL +46-31-691610 | [email protected] | www.audiodesign.pro www.marenius.com www.marenius.se
NoiseBox PowerPack PP-16,8Ah offers an easy way of supplying the portable
NoiseBox P1 internally, making it fully self-supplied for up to 100 hours.
In short, it is a jumpstart device for cars, with a battery and included cable sets.
It can start a car, charge various laptops and mobiles and power a P1.
Maximum capacity is 200 Wh. P1 uses approx. 2 W and it can be powered for up to 100
hours by a fully charged PowerPack.
WARNING!
PowerPack PP-16,8Ah is a lithium-
based battery capable of supplying a
very high current, up to 500 Amps in
jumpstart mode. Read the included
instruction before use of this feature.
Be careful not shorting the power
leads.
Use it with NoiseBox P1
The only parts needed is the PowerPack and
the short cable with two circular plugs.
1.
Plug the cable into the Output 12V socket in
PowerPack och plug the other end into the
DC socket labelled 12-24V, located next to
the ON/OFF switch in the panel of P1.
2.
Press the key for Power On on the
PowerPack. A LED bar will be lit showing
active output and current charge status.
3.
Put PowerPack inside the P1 case and press
the ON/OFF key located on the front panel of
P1. This will start the noise.
If it is not pressed with a minute the
PowerPack will turn off automatically. In that
case, repeat #2 (above).
Charging mobiles
For this purpose, do not use the USB outputs
in the P1, when it is powered by a
PowerPack. Instead, use the USB sockets in
the PowerPack.
When the P1 is turned off, PowerPack will
also turn off automatically.
Charging PowerPack
Charge state is indicated by LED’s on
PowerPack.
Use either the attached mains adapter or the
car adapter for charging PowerPack. Read
the attached instructions leaflet for more
information.
There you can also read about the various
ways of using the PowerPack (i.e. for jump
starting a car).
