Mareli Systems RubynoR AMG 1090, Руководство пользователя

Страница: 7 / 32

7
INSTALLATION
Device placement
Avoid installing the appliance near:
- places exposed to sunlight;
- close to heat sources;
- in damp rooms or in places with possible contact with water;
- in places with oily fumes
- in places exposed to high frequencies.
Make sure that:
- the wall on which the appliance is to be mounted is strong enough to support its weight;
- no pipes or electrical cables pass through the part of the wall in question;
- the wall in question is perfectly smooth;
- there is a place without obstacles that may obstruct the air flow at the entrance and exit;
- the mounting wall is preferably a wall from the outer perimeter, which allows condensate to drain
out during cooling mode ;
Installation methods
The following descriptions of the different phases of installation and the corre-
sponding designs refer to the version of the machine with fasteners on the left side.
The steps for mounting appliances with fasteners on the right side are the same.
Failure to comply with these rules may not only lead to a malfunction of the appliance, but will
also void the warranty and therefore MARELI SYSTEMS LTD will not be liable for any damage
caused to people, animals or property.
Minimum mounting distances
The figure below shows the minimum mounting distances between the wall-mounted cooling and
heating convector and the furniture in the room.
20 mm 20 mm
80 mm
400 mm
140 mm
2500 mm