Mareli Systems RubynoR AMG 1090, Руководство пользователя

Страница: 26 / 32

26
- In Setting Tap, Internal setting can be adjusted.
- Heat / Cool / Autochangeover mode can be
selected.
- Changeover Temp Heating / Cooling Setpoint
only effect when Autochangeover mode is se-
lected.
- Temperature offset is adjusted only when
there is difference between the actual temper-
ature and the measured value from thermostat.
- Thermostat clock will be synchronized when
“Sync” is pressed.
TA652FC-W Controller LCD Interface
Turn On/Off the thermostat
Press-n-Hold [On/Off Key] to turn On / Off the
thermostat. When the thermostat is Off, no Out-
put will be activated.
Clock setting
**Normally the clock is automatically set once
wifi is connected and synchronize for each
day. So manual set is not necessary when it is
online.
Press [CLOCK] to start the setting;
Press [ ] / [ ] to change the day of week;
Press [CLOCK] again to confirm day of week
setting and start to adjust hour;
Press [ ] / [ ] to change the hour;
Press [CLOCK] again to confirm hour setting
and start to adjust minutes;
Press [ ] / [ ] to change the minutes;
Press [CLOCK] again to confirm minutes set-
ting and start to adjust day of week;
Press [blank] to confirm or leave the clock set-
ting. Or return after no key pressed for 20 sec-
onds.
Clock synchronization
Controller syncs local time when it has access to
the internet. Please make sure it stays connected.
If you wish to sync network clock manually,
press the button on the App.
Schedule Programming
When 1 day / 5+1+1 day / 7day program is se-
lected in internal setting.
- Press-n-Hold on [Clock] to start the setting
- Press [ ] / [ ] to adjust the day of week
- Press [Clock] to confirm
- Press [ ] / [ ] to adjust the time of schedule
- Press [Clock] to confirm
- Press [ ] / [ ] to adjust the setpoint
- Press [Clock] to confirm
- Press [Blank] to exit
Override Temperature
The Set point can be adjusted by [ ] / [ ].
When it is in program mode, The set point will
be overridden until the next time slot. Press
[Clock] to release the override.
Internal Parameter Setting
- Press-n-hold on [Mode] key
- Press [Mode] to advance to the next item
- Press [ ] / [ ] to adjust the value
- Press [blank] to confirm and exit