3
Ø60mm
2.5Nm
(1)
(2)
(3)
(6)
Stud Solar 1
Stud Solar 2
(1)
(2)
(3)
2
3
(5)
(Fig 1)
(1)
(3)
(2)
1
2.5 Nm
4
STUD SOLAR
STUD
SOLAR
2.5 Nm
Connection of main supply cable (if available)
The main supply cable coming out of the pole must be connected as
follows:
Clamp mark F Live wire
Clamp mark N Neutral wire
Clamp mark T Ground wire
Movement sensor: Stud Solar 1/2 is pre-set for the connection of the
remote sensor through a terminal block placed inside the electrical
compartment. The sensor must be in "clean contact" with a supply
voltage between 12VDC and 17VDC
Untighten the screw
(1)
Loosen the screw
(2)
Remove the gear-tray cover
(3)
Insert Stud Solar 1 or Stud Solar 2 into the
pole by tightening the dowels
(6)
(2,5 Nm
strength)
Place the battery
(5)
(included) into the
compartment by placing the connectors in
the correct position
(see pic.1)
.
Reposition the gear-tray cover
(3)
Tighten the screws
(1 and 2)
*LEDs position in case
of grid connection
Installation of the fitting
*Grid connection: Pag. 7
Electronic circuit board pre-installed
and factory set (for programming
modes see pag.6-8)
User's manual
