Marco FRIIA 1000860 Series, Руководство по обслуживанию

Страница: 11 / 46

After about 3.5 minutes of continuous carbonation pump operation, without the usual
stops and starts dictated by the carbonation level probes the internal carbonation pump
controller shuts carbonation pump and LED starts blinking.
Refer to Troubleshooting chapter of this manual for corrective actions.
4.2 GREEN LIGHT TROUBLESHOOTING:
FRIIA Service manual Page 11
4.3 MAINTENANCE:
4.3.1 ROUTINE MAINTENANCE:
To always ensure good equipment operation, certain maintenance procedures (described
below) are required.
DAILY MAINTENANCE
1. Water font
Clean the font nozzle and remove any residual using warm water; do not use solvents or
abrasive detergents. If needed, remove all the limestone with a food descaling solution.
2. Drip tray
Clean the drip tray and remove any residual using warm water.
3. CO2 pressure
Review pressure CO2 gauges for proper settings.
4. Power cord
Check the condition of the power cord. Replace if necessary.