8716P Hybrid NVR Installation Guide
33
Unit Setup
5
Insert the hard drive into the bracket using the provided screws (four for each hard drive).
For the hard drive at the bottom of the bracket (position 2) the side with the exposed electronics
must be facing up (the label facing down). For the hard drive at the top of the bracket (position
1) the side with the exposed electronics must be facing down (the label facing up).
The data cable and power cable connections of the hard drives must face the left side of the
recorder when the hard drive bracket is in place.
Install and tighten the two screws on one side of a hard drive before installing and tightening
the two screws on the other side.
Note:
When tightening the screws, use 5.3 in-lbs (inch pounds) of torque.
6
For each position where you are installing a hard drive, locate the data and power cables and
connect both cables to the hard drive before you install the bracket back in the unit. The data
cables are marked with numbers to indicate which position they go in: attach the data cable
marked 1 to the hard drive in position 1.
Screws securing
hard drive in bracket
Data cable
Power cable
