www.
imPower
Dealer
.com
12
13
12
13
Step 10:
Carefully fold the extra wires inside the terminal box and place the top
control panel back on top of the terminal box.
Step 11:
The connection of the low voltage wires should be to the HOT Side (red
and black wire on the top side of the relay). Depending on the manufacturer
of the automation controller, you may need to remove the cover plate on these
relays to gain access to the terminals.
Step 12:
Wire the low voltage wires for the following speeds to be controlled:
High Speed
BLACK (+)
WHITE (-)
Medium Speed
BROWN (+)
BLUE (-)
Low Speed
RED (+)
GREEN (-)
Step 13:
Tighten three screws holding down the top control panel.
Step 14:
Replace and tighten the screws to mount the seal plate onto the motor.
Step 15:
Put a NEW pump seal into the seal plate and onto the motor shaft.
Handle and lubricate seal per manufacturer’s specifications.
Step 16:
Replace the impellor. Make sure that the impellor can spin freely
in the housing.
Step 17:
Replace the diffuser.
Step 18:
Replace and tighten the bolts that mounts the motor/seal plate to
the pump.
Step 19:
Prime the pump.
Step 20:
Reapply power to the motor.
The automation controller allows for all three speeds to be selected and operated
at any length of time. Note that the currently selected and operating speed must
be turned OFF prior to the selection of a new speed. The on time and speeds
should be set so that the pool can meet the total number of turns as required by
local/state regulations.
