Marantz VP8100, Руководство пользователя

Страница: 8 / 24

4
INTRODUCTION
ENGLISH
z
COMPONENT VIDEO IN
Y, P
B
/C
B
, P
R
/C
R
connectors.
Connect to the COMPONENT VIDEO output of video
equipment or an A/V processor/receiver with a component
video loop.
x
S-VIDEO IN
Connect to the S-VIDEO output of a video equipment.
c
VIDEO IN
Connect to the composite video output of a video equipment.
v
RGB IN
Connect to the analog RGB output of a computer equipment.
b
REMOTE SW. (EXTERNAL/INTERNAL)
When using the MARANTZ REMOTE CONTROL system, select
EXTERNAL. Otherwise select INTERNAL.
n
REMOTE CONTROL IN/OUT
Connect to the REMOTE CONTROL connectors of other
Marantz equipment. It is then possible to control the whole
system with a single Remote Controller.
m
TRIG.1 OUT
When the projector is turned on, a 12-volt signal is sent to the
equipment connected to the TRIG.1 OUT. This allows
automatic triggering of an accessory, such as a powered
up/down screen, whenever the projector is turned on or off.
When the unit is turned off, no voltage is output and when the
unit is turned on, 12 V is output.
Note:
You cannot use the connector as the power source.
,
TRIG.2 OUT
Either A 12-volt signal or a 0-volt signal is sent to the
equipment connected to the TRIG.2 OUT, according to the
setting in the OSD menu.
Note:
This cannot be used for these connectors, TRIG.1 OUT and
TRIG.2 OUT, as the power source.
.
Adjuster button
When using adjuster, press the button and loosen an adjuster.
⁄0
Adjuster
⁄1
Rear adjuster
Adjust the vertical angle of the projector.
⁄2
Ventilation holes
⁄3
IR sensor
⁄4
AC IN
Connect the supplied AC power cord.
EXT. INT. OUT
TRIG.2
REMOTE CONTROL
TRIG.1 RGB IN Y P
B
/C
B
COMPONENT VIDEO IN S-VIDEO
IN
VIDEO IN
P
R
/C
R
IN
n b c ⁄0 ⁄3 ⁄2
m , v z x
⁄4 ⁄1 ⁄2 ⁄0 ⁄0
.
Connector panel and Rear