4
T-Push Tm
T-Push Tm
T-PullCt
Disk Tray Open/Close Speed Adjustment
Open/Close speed of the tray can be changed.
When vibration occurs upon tray open/close and some unusual behavior happens, change the tray speed to stop
vibration.
Description of the terms displayed on FL
start
T-On Time open
Tray open
T-OffTim
start
T-On Time close
Tray close
T-OffTim
<Vibration on Disc Tray Open / Close>
Step 1.
With pressing DISPLAY and QUICK REPLAY buttons, press POWER button.
Step 2.
Press EASY JOG button.
“T-OnTime 015” (means Tray On Time 015ms default) is displayed.
Turn EASY JOG to change tray open/close speed from 000 to 255ms. Turn the number smaller to make the
open/close speed slower. Turn the number bigger to make the speed faster. Set bigger number to stop the tray
vibration. But the open/close speed becomes faster.
Press EASY JOG button again. The display changes as shown below so you can change other parameters
for the open/close speed.
Display
(Default Setting)
Description
Bigger Number
Smaller Number
T- OffTim 003
When open/close speed is too fast.
Note) 001, 002, 003 cannot be set.
open/close speed
becomes faster
open/close speed
becomes slower
T- PushTm 070
When vibration cannot be stopped
by adjusting T-OnTime.
open/close speed
becomes slower
open/close speed
becomes faster
T- PullCt 040
When disc clamp miss happens. Set smaller number to make it better.
Step 3. Press
EASY JOG button to complete adjustment.
Step 4. Press
STOP button to store the settings in memory.
To reset all the settings to default status, press number 0 button in Service Mode 0
(Display : Ver
P00). When miss-operated, press number 0 button to retry.
T-PushTm
DC driving time on Tray open operation.
Tray is DC driven at start opening.
Then Tray is driven by pulse.
Time can be set between 0-2550ms.
T-On Time
Duration time of High in pulse drive.
Time can be set between 0-255ms.
T-OffTim
Duration time of Low in pulse drive.
Time can be set between 0-255ms.
T-PullCt
The number of pulses on Tray close
operation.
