Marantz AV7706, Руководство пользователя

Страница: 277 / 326

Audyssey MultEQ ® XT32, Audyssey Dynamic EQ ® , Audyssey Dynamic Volume ® and Audyssey LFC™ cannot be selected.
0
These cannot be selected when you have not performed Audyssey ® Setup. (
v
p. 205)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. (
v
p. 133)
0
Audyssey Dynamic EQ ® , Audyssey Dynamic Volume ® and Audyssey LFC™ cannot be selected when sound mode is “DTS Virtual:X” or sound mode
that have “+ Virtual:X” in the sound mode name.
0
These cannot be selected when using the headphones.
“M-DAX” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “M-DAX” cannot be used. (
v
p. 176)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. (
v
p. 133)
No audio is output from PRE OUT for ZONE2/ZONE3.
0
In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/COAXIAL) are in 2ch PCM format.
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM format. To play back the audio in ZONE2
irrespective of the input signal format, set “HDMI Audio” in the menu to “PCM”. Depending on the played back device, the audio may not be played back
even with this setting. In that case, set the audio format to “PCM (2ch)” on the played back device. (
v
p. 246)
0
When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the Bluetooth device and this unit and use it
within a range of about 30 m.
Sound mode settings are not available when using Bluetooth headphones. Audio menu settings are also not available.
0
This unit cannot change sound mode or audio menu settings for audio output to Bluetooth headphones.
Contents Connections Playback Settings Tips Appendix
277
Front panel Display Rear panel Remote Index