Marani MIR-A Series, Руководство пользователя

Страница: 39 / 60

37
In example, use the processor A channel input, the
output channel 1 is connected to a 2 way passive
speaker, and the route is as shown in the above figure.
The output channel uses a M I R linear filter to
perform a virtual X-over on the speaker (it is be er to
k n o w t h e c ro s s o v e r Po i n t ) , s o t h a t d i ffe re nt
compressor ac va on thresholds can be set for the
high and low drivers, and at the same me, this
se ng will not destroy the original amplitude and
phase of the speaker, can add some color or an extra
protec on as required.
The channel level page displays the input post-A/D
and output pre-D/A signal levels of all channels,
corresponding to the physical level meter on the
front panel, where you can intui vely adjust the
channel level and mute.
A new func on called " Keep Linked CHs Level
Offset " has been added. The conven onal
linkage channel will link the level faders
together. For some ac ve speakers, the output
level ra o should remain the same. When this
happens, select "Keep Linked CHs Level Offset "
.The specific method is to assume that the
output channels need to be linked. When the
output channel linkage is turned on, turn on
the " Keep Linked CHs Level Offset " at the red
circle, so that the output channel can be linked
while maintaining the original ra o.
MIR-A
MIR-A Speaker Management
Software specification