Marani MIR-A Series, Руководство пользователя

Страница: 26 / 60

7.1 Connect with USB
When using the USB interface, directly connect to
the USB port of the PC with a B-type cable, add USB
to the so ware, and select the corresponding model .
7.2 Use network cable to connect
When using the network interface to connect, use a
Category 5/6 network cable to connect the Ethernet
port of the processor to the network adapter
interface of the PC, adjust the IPV4 address op on of
the corresponding network adapter in the Windows
network se ngs to automa cally obtain DHCP, and
then open the so ware Then the current processor
can be found automa cally. As shown ：
USB Cable
CAT5/6 CABLE
When using only one processor, you can use DHCP to
connect to the processor. The specific methods are
as follows:
The PC does not need to change the se ngs by
default, directly connect the Ethernet port of the PC
and the processor with a network cable, and open
the so ware in the CD to automa cally connect
.
When using mul ple processors, you can use a fixed
IP to reduce the error rate. You need to set the pc to
the same network segment as the processor, but
different IP addresses
.
24
MIR-A
MIR-A Speaker Management
Software specification
32
1
2
1
2
32
LAN