Certificate Number: 255416-2516776 Project Number: 2516776 Page Number:74
INSTALLATION AND OPERATION MANUAL
MARANA FORNI srl unipersonale
via Turbina 98 37139 Chievo-Verona-Italia
tel. +39 045 6704503 - fax +39 045 7156118
www.maranaforni.it - [email protected]
Skype: maranaforni
VER
2.1
© Riproduzione vietata
PAG
26 / 27
OVEN CLEANING OPERATIONS
Disconnect the power supply to the appliance before cleaning.
OVEN INTERIOR CLEANING OPERATIONS
Cleaning operations into the oven must be made with maximum 50° C (120F) inside temperature.
Cooking plate
:
use a long-handled brass brush for moving aside excess food particles accumulated during the
cooking operations.
DO NOT USE WATER OR ANY DETERGENT. DO NOT POUR OR SPRAY LIQUIDS:
THIS CAN DAMAGE THE OVEN AND WILL VOID THE WARRANTY.
If foods gets into the radiant flame
well and the radiant flame is visibly obstructed, immediately turn the oven
off and call the Factory, Factory Representative or a Local Service Company.
Factory or Factory Representative details and four details (model, series and matriculation number) are
indicated on the name plate on motor box exterior.
BURNER PROBLEMS CAUSED FROM DEBRIS WILL NOT BE COVERED BY WARRANTY.
MAKE EVERY ATTEMPT TO KEEP DEBRIS FROM DROPPING INTO THE RADIANT FLAME WELL.
Cooking room under cooking plate
–
ONLYFOR ROTOFORNO SU&GIU® SERIE:
WARNING:
The rotating cooking plate has a weight which varies from 220 to 400 kg. (from 485.02 Lbs to 881.85
Lbs) (depending on the oven model). Thus the machine has been equipped with specific valves which
do not allow the accident descent of the plate.
Lift up cooking plate to the summit of cooking room pressing
OFF
ON
and lifting up red joystick till having
≡≡≡
Lift up joystick to reach cooking plate level desired.
Disconnect the power supply to the appliance and clean under cooking plate with a vacuum cleaner with
suction pipe which is long enough to avoid entering below the plate with parts of the body.
Let down cooking plate pressing hydraulic pump button valve as followed, WITHOUT OPEN BOX MOTOR.
RING IN BRASS
REDUCTION SHAFT
AXIAL BEARING 51205
DUST DISC PROTECION
OLEODINAMIC CILINDER
VALVE PARACHUTE
SUPPORTING HOTPLATE SHAFT
SUPPORT BEARING
REDUCTION ENGINE SUPPORT
PIVOT Ø14x44
ELECTRIC MATERIAL BOX
PUMP ENGINE
REDUCTION ENGINE
BEARING LEAD SHAFT
COMPRESSION SPRING
11
14
15
13
12
8
10
9
5
6
7
COMPONENT
2
3
4
N°
1
STEAL SPHERE Ø12
16
8
14
16
15
13
12
10
11
9
10
9
4
1
7
3
6
2
5
