6
□
Read all instructions and warning prior to operating the appliance.
□
Ensure that all controls are in the “OFF” position before plugging the appliance in to a properly grounded electrical outlet.
□
The main control panel is located behind the cover at the top right corner on the front.
Care and Maintenance
WARNING: Always disconnect from the power supply before
cleaning the heater. First turn off the main power. Then remove
the electrical plug from the wall outlet.
The blower motor and flame motor are pre-lubricated and need no further lubrication or maintenance. Use the soft brush attachment of a vacuum
cleaner to remove accumulation of dust or fluff from the outlet grille of the fan heater.
□
Use a soft, clean cloth that will not scratch the surface when dusting.
□
Use a clean soft cloth dampened with warm water to clean the fireplace surface. DO NOT use household or abrasive cleaners, as these
products may damage the surface.
□
When cleaning the glass viewing screen use a non-abrasive damp cloth with liquid cleaner or soft soap if necessary; DO NOT use
cleaning powders or any other substance with abrasives since these substances will scratch glass.
□
Under no circumstances should this product be operated with a broken or chipped glass panel.
□
Do not strike or slam the glass.
□
In the event that your appliance is stained or otherwise damaged during use, we recommend that you call a professional to repair your
furniture.
□
When not in use please unplug the cord from the outlet to prevent any damage or accidental plug of the cord.
Troubleshooting
Problem
Solution
The unit does not turn on.
Check that the unit is plugged into a standard
220
V outlet.
Press the power button on the control panel.
The unit is on, but there is no flame effect.
Open the back panels to check if the flame spindle has fallen off
from the spindle motor.
There is a visible flame effect, but the heater does not blow warm
air.
Turn on/off the heater button several times to make sure it is in the
“ON” position.
The heater does not work, but the power and heater switches are
in the “ON” position.
Turn all switches to the “OFF” position and unplug the unit from the
wall outlet for 5 minutes. After 5 minutes plug the unit back into the
wall outlet, and operate as normal.
Operation
WARNING: Do not use this fireplace insert if any part of it has
been under water. Immediately call a qualified service
technician to inspect the firebox and replace any part of the
electrical system which has been under water.
