ASSEMBLY TEMPLATE
NOTE:
1.
REVISION LEVEL
EMK
10/26/16
CREATED DRAWING
REV.
A
-
DWN
TITLE:
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
STUDENT SERVICE ISLAND
STUDENT SERVICE ISLAND-SINGLE
ASSEMBLY INSTRUCTIONS
REV A
4 OF 6
NTS
EMK
10/26/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
STEP 4:
WITH HELP FROM ANOTHER PERSON, PLACE RIGHT APRON ASSEMBLY
UP TO SIDE AND ATTACH TO L BRACKETS WITH REMAINING SCREWS
PROVIDED. IT IS IMPORTANT THAT THE WING IS SUPPORTED UNTIL THE
LEGS ARE IN PLACE . REPEAT FOR LEFT SIDE.
STEP 5:
SLIDE LEG BOOT ONTO LEG
WITH FLARED END TOWARDS
BOTTOM OF LEG. SCREW LEG
LEVELER INTO T-NUT ON
BOTTOM OF THE LEG. REPEAT
FOR OTHER LEG.
STEP 6:
INSERT HANGER BOLT ON ONE OF THE LEGS THROUGH
THE CORNER BRACKET AND INSERT LOCK WASHER
AND HEX NUT. TIGHTEN NUT USING A
1
2
" WRENCH OR
1
2
" SOCKET AND TORQUE WRENCH, TO A MINIMUM OF
12FT LBS BUT NOT TO EXCEED 17FT LBS . REPEAT FOR
OTHER LEG. DO NOT APPLY PRESSURE TO THE WINGS
AT THIS TIME. THEY ARE NOT STRONG ENOUGH TO
WITHSTAND WEIGHT UNTIL TOP IS ATTACHED.
STEP 7:
ADJUST LEG LEVELERS TO LEVEL THE TABLE. APPLY SILICONE ADHESIVE
TO TOP EDGES OF THE CABINET AND WINGS. PLACE TOP ON UNIT WITH
PROPER OVERHANG (2" OVERHANG ON SIDES AND 1.25" ON FRONT
AND BACK). CLAMP ON TOP TO THE WINGS TO REMOVE ANY WARP
USING SHIMS AND C-CLAMPS, IF NEEDED, WHEN ALIGNING THE TOP
(DO THIS BEFORE ADHESIVE ON EDGES SETS UP). LET CURE FOR 6-12
HOURS. DO NOT APPLY SILICONE ADHESIVE TO BACK PANEL .
HOLD APRON ASSEMBLY
UP UNTIL LEGS HAVE
BEEN ATTACHED
ATTACH APRON
ASSEMBLY TO L BRACKETS
LEG LEVELER
LEG BOOT
INSERT HANGER BOLT
THROUGH HERE WITH LOCK
WASHER AND HEX NUT
CLOSE UP OF LEG LEVELER AND
LEG BOOT ASSEMBLY
CLOSE UP OF CORNER BRACKET
ASSEMBLY
TOP VIEW OF TABLE SHOWN
APPLY SILICONE
ADHESIVE TO TOP EDGES
OF WINGS AND CABINET
DO NOT APPLY SILICONE
ADHESIVE TO BACK PANEL
& C2710KF SERIES.dwg, 12/2/2016 12:00:36 PM, DWG To PDF.pc3
