L.
Stationary appliances not fitted with means for disconnection from
the supply mains having a contact separation in all poles that
provide full disconnection under over voltage category III, the
instructions state that means for disconnection must be
incorporated in the fixed wiring in accordance with the wiring rules.
M.
Ensure the grille is fully engaged onto the fan chassis using all
clips.
N.
Cleaning and user maintenance shall not be made by children.
ACCESSORIES
(not supplied)
WALL FITTING KIT
A range of 100mm wall kits are available for installing into most walls using liners supplied.
INSTALLATION
IMPORTANT:
The fan should only be used in
conjunction with fixed wiring.
PANEL/CEILING MOUNTING
1.
For panel/ceiling mounting the fan should be installed into a closed duct protected by an exterior air
grille that must comply with the standard requirements of your country.
2.
Cut a 105mm diameter hole for 100mm fans.
3.
Push the two clips on each side of the fan and pull the grille away from the chassis.
4.
Mark the screw centres through the holes in the fan back plate. Drill, plug and screw into position.
5.
After installation, ensure impeller rotates freely and the shutters can open.
6.
Replace the grille and ensure the clips reactivate.
WALL MOUNTING
1.
For wall mounting either cut a 115mm diameter hole for 100mm fans, through the wall and insert the
wall sleeve. Slope the sleeve slightly downwards away from the fan. Cut to length and cement both
ends into position flush with the wall faces.
2.
Push the two clips on each side of the fan and pull the grille away from the chassis.
3.
Mark the screw centres through the holes in the fan back plate. Drill, plug and screw into position.
Fix exterior grille into position with the louvres positioned downwards. (Note:- The grille must
comply with the standard requirements of your country. The wall kit used in this installation should
provide a minimum ducting length of 100mm from the fans back plate to the inside of the external
grille).
4.
After installation, ensure impeller rotates freely and the shutters can open.
5.
Replace the grille and ensure the clips reactivate.
